Antenna Kit C - Yagi 400 MHz

  1. Mount the omnidirectional antenna. Please refer to the Omnidirectional Antenna section.
  2. Screw the splitter to the antenna mount with two screws M3 x 30 mm.
../imgs/combiner.png

Note

The splitter receives an electrical signal and sends it to two different antennas.

  1. Attach both adapters for the Yagi antenna with eight screws M3 x 16 mm and their corresponding washers.
../imgs/adapter_yagi.png

Note

The space between adapters can be adjusted according to the width of the antenna.

../imgs/move.png

  1. Insert the Yagi antenna into the adapter according to the polarity. The polarity direction is indicated by an arrow on the antenna.
../imgs/insert_yagi_400.png
  1. Screw the Yagi antenna to the adapters with two screws M6 x 45 mm and their corresponding knobs.
../imgs/screw_yagi_400.png
  1. Connect each plug of the splitter.
../imgs/connect.png
1 Port RF2 of PCS
2 Omnidirectional antenna
3 Yagi antenna

© 2026 Embention. All rights reserved.